The FCM-1-ISO Addressable Control Module are intended for use in intelligent, two-wire systems, where the individual address of each module is selected using the built-in rotary switches. It provides Notifier intelligent fire alarm control panels a circuit for Notification Appliances (horns, strobes, speakers, etc.). Addressability allows the FCM-1-ISO to be activated, either manually or through panel programming, on a select (zone or area of coverage) basis.

Features
Built-in type identification automatically identifies these devices to the control panel.
Internal circuitry and relay powered directly by two-wire SLC loop. The FCM-1-ISO module requires power (for horns, strobes, etc.), or audio (for speakers).
Integral LED “blinks” green each time a communication is received from the control panel and turns on in steady red when activated.
LED blink may be deselected globally (affects all devices).
The FCM-1-ISO may be used to switch 24-volt NAC power, audio (up to 70.7 Vrms).
Wide viewing angle of LED.
SEMS screws with clamping plates for wiring ease.
Direct-dial entry of address 01– 159 for FlashScan loops, 01 – 99 for CLIP mode loops.
Speaker, and audible/visual applications may be wired for Class B or A (Style Y or Z).
The FCM-1-ISO & FRM-1-ISO include an isolation circuit, when short circuit occurs, FCM-1-ISO & FRM-1-ISO will cut off the connection of the devices which are in the back-end. And when the short fault removes, these devices will be reconnected.

DOWNLOAD